Alcatel OmniStack LS 6248 User Manual page 226

3
Configuring the Switch
Interface Settings Page.
Command Attributes
• Instance ID — Lists the MSTP instances configured on the device. Possible field
range is 0-15.
• Interface — Displays the interface for which the MSTP settings are displayed. The
possible field values are:
• Port — Specifies the port for which the MSTP settings are displayed.
• LAG — Specifies the LAG for which the MSTP settings are displayed.
• STP Port Status — Indicates if STP is enabled on the port. The possible field
values are:
• Enabled — Indicates that STP is enabled on the port.
• Disabled — Indicates that STP is disabled on the port.
• Port State — Indicates whether the port is enabled for the specific instance. The
possible field values are:
• Enabled — Enables the port for the specific instance.
• Disabled — Disables the port for the specific instance.
• Type — Indicates whether the port is a Boundary or Master port. The possible field
values are:
• Boundary Port — Indicates that the port is a Boundary port. A Boundary port
attaches MST bridges to LANs in an outlying region. If the port is a Boundary
port, this field also indicates whether the device on the other side of the link is
working in RSTP or STP mode
• Master Port — Indicates the port is a master port. A Master port provides
connectivity from a MSTP region to the outlying CIST root.
• Role — Indicates the port role assigned by the STP algorithm to provide to STP
paths. The possible field values are:
• Root — Provides the lowest cost path to forward packets to the root device.
• Designated — Indicates the port or LAG through which the designated device
is attached to the LAN.
• Alternate — Provides an alternate path to the root device from the root interface.
• Backup — Provides a backup path to the designated port path toward the
Spanning Tree leaves. Backup ports occur only when two ports are connected
in a loop by a point-to-point link or when a LAN has two or more connections
connected to a shared segment.
• Disabled — Indicates the port is not participating in the Spanning Tree.
• Mode — Indicates the STP mode by which STP is enabled on the device. The
possible field values are:
• Classic STP — Classic STP is enabled on the device. This is the default value.
• Rapid STP — Rapid STP is enabled on the device.
• Multiple STP — Multiple STP is enabled on the device.
• Interface Priority — Defines the interface priority for the specified instance. The
default value is 128.
202