Alcatel OmniStack LS 6248 User Manual page 500

4
Command Line Interface
Command Usage
Action serviced to a class, so that if an IP packet arrives, the queue is
assigned per DSCP. If a non-IP packet arrives, the queue is assigned per CoS
(VPT).
Example
The following example configures the trust state for a class called class1 in a policy
map called policy1.
Console (config)# policy-map policy1
Console (config-pmap)# class class1
Console (config-pmap-c)# trust cos-dscp
Related Commands
set
set
The Policy-map Class Configuration mode command sets new values in the IP
set
packet.
Syntax
{ new-dscp |
set dscp
no set
Parameters
• new-dscp — Specifies a new DSCP value for the classified traffic
(Range: 0-63).
• queue-id — Specifies an explicit queue ID for setting the egress queue.
• new-cos — Specifies a new user priority for marking the packet
(Range: 0-7).
Default Setting
This command has no default configuration.
Command Mode
Policy-map Class Configuration mode
Command Usage
This command is mutually exclusive with the
Configuration command within the same policy map.
Policy maps that contain
commands or that have ACL classifications cannot be attached to an egress
interface by using the
Configuration mode command.
To return to the Policy-map Configuration mode, use the
return to privileged EXEC mode, use the
476
queue-id |
queue cos
or Policy-map Class Configuration
set trust
(Ethernet, Port-channel) Interface
service-policy
new-cos}
Policy-map Class
trust
exit
command.
end
command. To