Link Aggregation And Qos Example - Alcatel OmniSwitch 6624 Network Configuration Manual
Hide thumbs
Also See for OmniSwitch 6624:
- Troubleshooting manual (614 pages) ,
- Management manual (264 pages) ,
- Network configuration manual (654 pages)
Table of Contents
Advertisement
Application Examples
Link Aggregation and QoS Example
As shown in the figure on
tion, has been configured to use dynamic aggregate group 7. The actual physical links connect ports 4/1,
4/2, 4/3, and 4/4 on Switch A to ports 1/1, 1/2, 1/3, and 1/4 on Switch C (a stack of four OmniSwitch 6648
switches). Follow the steps below to configure this network:
Note. Only the steps to configure the local (i.e., Switch A) are provided here since the steps to configure
the remote (i.e., Switch C) would not be significantly different.
1
Configure dynamic aggregate group 7 by entering:
-> lacp linkagg 7 size 4
2
Configure ports 4/1, 4/2, 4/3, and 4/4 the same actor administrative key (7) by entering:
-> lacp agg 4/1 actor admin key 7
-> lacp agg 4/2 actor admin key 7
-> lacp agg 4/3 actor admin key 7
-> lacp agg 4/4 actor admin key 7
3
Create VLAN 12 by entering:
-> vlan 12
4
Configure 802.1Q tagging with a tagging ID (i.e., VLAN ID) of 12 on dynamic aggregate group 7 by
entering:
-> vlan 12 802.1q 7
5
If the QoS Manager has been disabled (it is enabled by default) enable it by entering:
-> qos enable
Note. Optional. Use the
disabled.
6
Configure a policy condition for VLAN 12 called "vlan12_condition" by entering:
-> policy condition vlan12_condition destination vlan 12
7
Configure an 802.1p policy action with the highest priority possible (i.e., 7) for VLAN 12 called
"vlan12_action" by entering:
-> policy action vlan12_action 802.1P 7
8
Configure a QoS rule called "vlan12_rule" using the policy condition and policy rules you configured
in steps 8 and 9 above by entering:
-> policy rule vlan12_rule enable condition vlan12_condition action
vlan12_action
9
Enable your 802.1p QoS settings by entering qos apply as shown below:
-> qos apply
page 11-34
page
11-32, VLAN 12, which uses 802.1Q frame tagging and 802.1p prioritiza-
show qos config
command to determine if the QoS Manager is enabled or
OmniSwitch 6624/6648 Network Configuration Guide
Configuring Dynamic Link Aggregation
April 2004
Advertisement
Table of Contents
