Flowcontrol; Mdix - Alcatel OmniStack LS 6248 User Manual

flowcontrol

The Interface Configuration (Ethernet, port-channel) mode command
flowcontrol
configures flow control on a given interface. To disable flow control, use the
of this command.
Syntax
{
flowcontrol auto | on
no flowcontrol
Parameters
• — Indicates auto-negotiation
auto
• on — Enables flow control.
• — Disables flow control.
off
Default Setting
Flow control is off.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
Command Usage
Negotiation should be enabled for
Flow control can be configured only in full duplex mode.
Example
In the following example, flow control is enabled on port 1/e5.
Console(config)#
Console(config-if)#
Related Commands
shutdown
speed
duplex
negotiation

mdix

back-pressure
show interfaces configuration
show interfaces status
mdix
The Interface Configuration (Ethernet) mode command enables cable
mdix
crossover on a given interface. To disable cable crossover, use the
command.
| }
off
interface ethernet
flowcontrol on
Ethernet Configuration Commands
.
flow control auto
1/e5
4
form
no
form of this
no
383