Spanning-Tree Bpdu - Alcatel OmniStack LS 6248 User Manual

4
Command Line Interface
Default Setting
Short path cost method.
Command Mode
Global Configuration mode
Command Usage
This command applies to all spanning tree instances on the device.
The cost is set using the
Example
The following example sets the default path cost method to
Console(config)#
Related Commands
show spanning-tree

spanning-tree bpdu

The
spanning-tree bpdu
handling when the spanning tree is disabled globally or on a single interface. To
return to the default configuration, use the
Syntax
spanning-tree bpdu
no spanning-tree bpdu
Parameters
•
filtering
are filtered.
•
flooding
BPDU packets are flooded unconditionally (Without applying VLAN rules),
to all ports which have Spanning Tree disabled.
•
bridging
BPDU packets are flooded, and are subject to ingress and egress VLAN
rules. This mode is not relevant if Spanning Tree is disabled only on a group
of ports.
Default Setting
The default setting is flooding.
Command Modes
Global Configuration mode
Command Usage
There are no user guidelines for this command.
550
spanning-tree cost
spanning-tree pathcost method long
Global Configuration mode command defines BPDU
{ |
filtering flooding
— When Spanning Tree is disabled on an interface, BPDU packets
— When Spanning Tree is disabled on an interface, untagged
— When Spanning Tree is globally disabled, untagged or tagged
command.
long
no form of this command.
| }
bridging
.