Ip Arp Inspection Logging Interval; Show Ip Arp Inspection - Alcatel OmniStack LS 6248 User Manual

4
Command Line Interface

ip arp inspection logging interval

The ip arp inspection logging interval Global Configuration mode command
configures the minimal interval between successive ARP SYSLOG messages. To
return to the default configuration, use the no form of this command.
Syntax
ip arp inspection logging interval {seconds | infinite}
no ip arp inspection logging interval
Parameters
• seconds — Specifies the minimal interval between successive ARP
SYSLOG messages. A 0 value means that a system message is
immediately generated. (Range: 0-86400)
• infinite — Specifies SYSLOG messages are not generated.
Default Configuration
The default value is 5 seconds.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example sets the minimum ARP SYSLOG message interval to 10
seconds.
Console # (config)# ip arp inspection logging interval 10
Console # (config)#

show ip arp inspection

The show ip arp inspection EXEC mode command displays the ARP inspection
configuration.
Syntax
show ip arp inspection [ethernet interface | port-channel
port-channel-number]
Parameters
• interface — Specifies an Ethernet port.
• port-channel-number — Specifies a port-channel number.
Default Configuration
This command has no default configuration.
Command Mode
EXEC
650