3
Configuring the Switch
Apply.
CLI – The following is an example of the GVRP configuration commands:
Console(config)#
4-399
Console(config)#
4-376
Console(config-if)#
4-399
Console(config-if)#
4-402
Console(config-if)#
4-402
Viewing GVRP Statistics
The GVRP Statistics Page contains device statistics for GVRP.
Command Attributes
• Interface—Specifies the interface type for which the statistics are displayed.
• Port—Indicates port statistics are displayed.
• LAG—Indicates LAG statistics are displayed.
• Refresh Rate—Indicates the amount of time that passes before the GVRP
statistics are refreshed. The possible field values are:
• 15 Sec—Indicates that the GVRP statistics are refreshed every 15 seconds.
• 30 Sec—Indicates that the GVRP statistics are refreshed every 30 seconds.
• 60 Sec—Indicates that the GVRP statistics are refreshed every 60 seconds.
220
Figure 3-110. GVRP Parameters Page
gvrp enable
interface ethernet
gvrp enable
gvrp vlan-creation-forbid
gvrp registration-forbid
1/e6