Snmp-Server Engineid Local - Alcatel OmniStack LS 6248 User Manual

only required, 16 bytes should be entered; if authentication and privacy are
required, 32 bytes should be entered. Each byte in the hexadecimal
character string is two hexadecimal digits. Each byte can be separated by
a period or colon. (16 or 32 bytes)
•
auth-sha-key
level. The user should enter a concatenated hexadecimal string of the SHA
key (MSB) and the privacy key (LSB). If authentication is only required, 20
bytes should be entered; if authentication and privacy are required, 36
bytes should be entered. Each byte in the hexadecimal character string is
two hexadecimal digits. Each byte can be separated by a period or colon.
(20 or 36 bytes)
Default Setting
No group entry exists.
Command Mode
Global Configuration mode
Command Usage
If auth-md5 or auth-sha is specified, both authentication and privacy are
enabled for the user.
When a
show running-config
line for this user will not be displayed. To see if this user has been added to
the configuration, type the
command.
An SNMP EngineID has to be defined to add SNMP users to the device.
Changing or removing the SNMP EngineID value deletes SNMPv3 users from
the device's database.
The remote engineid designates the remote management station and should
be defined to enable the device to receive informs.
Example
The following example configures an SNMPv3 user
Console(config)#
Related Commands
show snmp users

snmp-server engineID local

The
snmp-server engineID local
Simple Network Management Protocol (SNMP) engineID on the local device. To
remove the configured engine ID, use the
Syntax
snmp-server engineID local
sha-des-keys — Indicates the HMAC-SHA-96 authentication
Privileged EXEC mode command is entered, a
show snmp users
snmp-server user
Global Configuration mode command specifies the
{engineid-string |
Privileged EXEC mode
in group
John
John user-group
form of this command.
no
}
default
4
SNMP Commands
.
user-group
523