Dot1X Multiple-Hosts - Alcatel OmniStack LS 6248 User Manual

4
Command Line Interface
Examples
The following example enables access to the VLAN to unauthorized devices.
Console(config-if)
Related Commands
show dot1x advanced

dot1x multiple-hosts

The
dot1x multiple-hosts
hosts (clients) on an 802.1X-authorized port, where the authorization state of the
port is set to
auto
command.
Syntax
dot1x multiple-hosts [authentication]]
no dot1x multiple-hosts
Parameters
•
authentication
authenticated.
Default Configuration
Multiple hosts are disabled.
Command Mode
Interface Configuration (Ethernet) mode
Command Usage
This command enables the attachment of multiple clients to a single
802.1X-enabled port.
If you use this command without the authentication keyword, only one of the
attached hosts must be successfully authorized for all hosts to be granted
network access. If the port becomes unauthorized, all attached clients are
denied access to the network.
If you use this command with the authentication keyword, each host must be
successfully authorized in order to grant network access. Please note that
packets are NOT encrypted, and after success full authentication filtering is
based on the source MAC address only.
For unauthenticated VLANs multiple hosts are always enabled.
Port security on a port cannot be enabled if the port if multiple hosts are
disabled or multiple hosts are enabled with authentication per host.
282
# dot1x auth-not-req
Interface Configuration mode command enables multiple
. To return to the default configuration, use the
— Specifies that each station should be 802.1x
form of this
no