Syntax
back-pressure
no back-pressure
Default Setting
Back pressure is enabled.
Command Mode
Interface Configuration (Ethernet) mode
Command Usage
The back pressure Interface Configuration mode command enables back
pressure on half duplex mode only, therefore it can not be configured on a
channel port.
Example
In the following example back pressure is enabled on port 1/e5.
Console(config)#
Console(config-if)# back-pressure
Related Commands
shutdown
speed
duplex
negotiation
flowcontrol
mdix
show interfaces configuration
show interfaces status
clear counters
The
clear counters
Syntax
clear counters
Parameters
• interface — Valid Ethernet port. (Full syntax: unit/port)
• port-channel-number — Valid port-channel number.
Default Setting
This command has no default configuration.
interface ethernet
User EXEC mode command clears statistics on an interface.
[
interface |
ethernet
Ethernet Configuration Commands
1/e5
port-channel-number]
port-channel
4
385