Autobaud; Exec-Timeout - Alcatel OmniStack LS 6248 User Manual

autobaud

The Line Configuration mode command sets the line for automatic baud
autobaud
rate detection (autobaud). To disable automatic baud rate detection, use the
of the command.
Syntax
autobaud
no autobaud
Default Setting
Autobaud is disabled.
Command Mode
Line Configuration (console) mode
Command Usage
This command is available only on the line console.
To start communication using Autobaud , press
configuration applies only to the current session.
Example
The following example enables autobaud.
Console(config)#
Console(config-line)#
Related Commands
show line

exec-timeout

The Line Configuration mode command sets the interval that the
exec-timeout
system waits until user input is detected. To return to the default configuration, use
the form of this command.
no
Syntax
minutes [seconds]
exec-timeout
no exec-timeout
Parameters
• minutes — Specifies the number of minutes. (Range: 0 - 65535)
• seconds — Specifies additional time intervals in seconds. (Range: 0 - 59)
Default Setting
The default configuration is 10 minutes.
Command Mode
Line Configuration mode
line console
autobaud
Line Commands
twice. This
<Enter>
4
form
no
439