Port Storm-Control Broadcast Enable - Alcatel OmniStack LS 6248 User Manual

The following table describes the fields shown in the display:
Field
InOctets
InUcastPkts
InMcastPkts
InBcastPkts
OutOctets
OutUcastPkts
OutMcastPkts
OutBcastPkts
FCS Errors
Single Collision Frames
Late Collisions
Oversize Packets
Internal MAC Rx Errors
Received Pause Frames
Transmitted Pause Frames
Related Commands
clear counters

port storm-control broadcast enable

The
port storm-control broadcast enable
command enables broadcast storm control. To disable broadcast storm control, use
the form of this command.
no
Syntax
port storm-control broadcast enable
no port storm-control broadcast enable
Default Setting
Broadcast storm control is disabled.
Ethernet Configuration Commands
Description
Counted received octets.
Counted received unicast packets.
Counted received multicast packets.
Counted received broadcast packets.
Counted transmitted octets.
Counted transmitted unicast packets.
Counted transmitted multicast packets.
Counted transmitted broadcast packets.
Counted received frames that are an integral number of octets
in length but do not pass the FCS check.
Counted frames that are involved in a single collision, and are
subsequently transmitted successfully.
Number of times that a collision is detected later than one
slotTime into the transmission of a packet.
Counted frames received that exceed the maximum permitted
frame size.
Counted frames for which reception fails due to an internal MAC
sublayer receive error.
Counted MAC Control frames received with an opcode
indicating the PAUSE operation.
Counted MAC Control frames transmitted on this interface with
an opcode indicating the PAUSE operation.
Interface Configuration (Ethernet) mode
4
395