Negotiation - Alcatel OmniStack LS 6248 User Manual

4
Command Line Interface

negotiation

The Interface Configuration (Ethernet, port-channel) mode command
negotiation
enables auto-negotiation operation for the speed and duplex parameters of a given
interface. To disable auto-negotiation, use the
Syntax
negotiation
no negotiation
Parameters
• capability — Specifies the capabilities to advertise. (Possible values: 10h,
10f, 100h,100f, 1000f)
Default Setting
Auto-negotiation is enabled.
If unspecified, the default setting is to enable all capabilities of the port.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
Command Usage
If capabilities were specified when auto-negotiation was previously entered,
not specifying capabilities when currently entering auto-negotiation overrides
the previous configuration and enables all capabilities.
Example
The following example enables auto-negotiation on Ethernet port 1/e5.
Console(config)#
Console(config-if)#
Related Commands
shutdown
speed
duplex
flowcontrol
mdix
back-pressure
show interfaces advertise
show interfaces configuration
show interfaces status
382
[capability1 [capability2...capability5]]
interface ethernet
negotiation
form of this command.
no
1/e5