Port Monitor Commands - Alcatel OmniStack LS 6248 User Manual

4
Command Line Interface

Port Monitor Commands

Command
port monitor
show ports monitor
port monitor
The
port monitor
session. To stop a port monitoring session, use the
Syntax
port monitor
no port monitor
Parameters
• src-interface — Valid Ethernet port. (Full syntax: unit/port)
• Monitors received packets only.
rx —
• tx — Monitors transmitted packets only.
Default Setting
Monitors both received and transmitted packets.
Command Mode
Interface Configuration (Ethernet) mode
Command Usage
This command enables traffic on one port to be copied to another port, or
between the source port (src-interface) and a destination port (port being
configured).
The following restrictions apply to ports configured as destination ports:
• The port cannot be already configured as a source port.
• The port cannot be a member in a port-channel.
• An IP interface is not configured on the port.
• GVRP is not enabled on the port.
• The port is not a member of a VLAN, except for the default VLAN (will
automatically be removed from the default VLAN).
• The following restrictions apply to ports configured to be source ports:
• The port cannot be already configured as a destination port.
458
Table 4-22. Port Monitor Commands
Function
Starts a port monitoring session. To stop a port monitoring
session, use the no form of this command.
Displays the port monitoring status.
Interface Configuration mode command starts a port monitoring
src-interface
[rx | tx]
src-interface
Mode
ICE
UE
form of this command.
no
Page
4-458
4-459