Qos Map Dscp-Queue - Alcatel OmniStack LS 6248 User Manual

4
Command Line Interface
Parameters
• dscp- list — Specifies up to 8 DSCP values separated by a space.
(Range: 0-63)
• dscp-mark-down — Specifies the DSCP value to mark down. (Range: 0-63)
Default Setting
The default map is the Null map, which means that each incoming DSCP
value is mapped to the same DSCP value.
Command Mode
Global Configuration mode.
Command Usage
DSCP values 3,11,19... cannot be remapped to other values.
·
Example
The following example marks down incoming DSCP value 3 as DSCP value 43 on
the policed-DSCP map.
Console(config)#
Reserved DSCP. DSCP 3
Related Commands
show qos interface

qos map dscp-queue

qos map dscp-queue
The
qos map dscp-queue
to CoS map. To return to the default map, use the
Syntax
qos map dscp-queue
no qos map dscp-queue
Parameters
• dscp-list — Specifies up to 4 DSCP values separated by a space.
(Range: 0 - 63)
• queue-id — Specifies the queue number to which the DSCP values are
mapped.
Default Setting
The following table describes the default map.
DSCP
value
Queue-ID
488
qos map policed-dscp
was not configured.
Global Configuration mode command modifies the DSCP
dscp-list queue-id
to
0-15 16-31
1 2
to
3 43
form of this command.
no
32-47 48-63
3 4