Alcatel OmniStack LS 6248 User Manual page 478

4
Command Line Interface
Command Usage
To test optical transceivers, ensure a fiber link is present.
Examples
The following examples display the optical transceiver diagnostics.
show fiber-ports optical-transceiver
Console#
Port Temp
---- ----
1/g1 W
1/g2 OK
1/g3 Copper
Temp – Internally measured transceiver temperature.
Voltage - Internally measured supply voltage.
Current – Measured TX bias current.
Output Power – Measured TX output power.
Input Power – Measured RX
Tx Fault – Transmitter fault
LOS – Loss of signal
N/A - Not Available, N/S - Not Supported, W - Warning, E - Error
show fiber-ports optical-transceiver detailed
Console#
Port Temp
[C]
---- ----
1/g1 48
1/g2 43
1/g3 Copper
Temp – Internally measured transceiver temperature.
Voltage - Internally measured supply voltage.
Current – Measured TX bias current.
Output Power – Measured TX output power.
Input Power – Measured RX
Tx Fault – Transmitter fault
LOS – Loss of signal
454
Voltage Current
------- -------
OK E
OK OK
received power.
Voltag Current
e
[Volt] [mA]
------ -------
5.15 50
5.15 10
received power.
Power
Output Input
------ -----
OK OK
OK OK
Power
Output Input
[mWatt] [mWatt]
------ -----
1.789 1.789
1.789 1.789
TX Fault LOS
------- ---
OK OK
E OK
TX Fault LOS
------- ---
No No
No No