Ip Source-Guard Tcam Retries-Freq - Alcatel OmniStack LS 6248 User Manual

4
Command Line Interface
Example
The following example configures the static IP source bindings on the switch for port
1/e16.
Console # (config)# ip source-guard binding 00:60:70:4C:73:FF 1
10.6.22.195 ethernet 1/e16
Console # (config)#

ip source-guard tcam retries-freq

The ip source-guard tcam retries-freq Global Configuration mode command
configures the frequency of retries for TCAM resources for inactive IP source guard
addresses. To return to the default configuration, use the no form of this command.
Sytnax
ip source-guard tcam retries-freq {seconds | never}
no ip source-guard tcam retries-freq
Parameters
• seconds — Specifies, in seconds, the retries frequency. (Range: 10 – 600)
• never — Specifies to not perform an automatic search for TCAM resources.
Default Configuration
The default value is 60.
Command Mode
Global Configuration mode
User Guidelines
Since the IP source guard uses the Ternary Content Addressable Memory
(TCAM) resources, there may be situations where IP source guard addresses
are inactive because of a lack of TCAM resources.
By default, every minute the software conducts a search for available space in
the TCAM for the inactive IP source guard addresses. You can use this
command to change the frequency or to disable automatic retries for TCAM
space.
The ip source-guard tcam locate Privileged EXEC mode command manually
retries locating TCAM resources for the inactive IP source guard addresses.
The show ip source-guard inactive EXEC mode command displays the
inactive IP source guard addresses.
642