Figure 3-113. Multicast Group Page - Alcatel OmniStack LS 6248 User Manual

3
Configuring the Switch
• Checked — Enables Multicast filtering on the device.
• Unchecked — Disables Multicast filtering on the device. If Multicast filtering is
disabled, Multicast frames are flooded to all ports in the relevant VLAN.
Disabled is the default value.
• VLAN ID — Identifies a VLAN and contains information about the Multicast group
address.
• Bridge Multicast Address — Identifies the Multicast group MAC address/IP
address.
• Ports — Displays Port that can be added to a Multicast group.
• LAGs — Displays LAGs that can be added to a Multicast Group.
CLI – The following is an example of the Multicast Group CLI commands:
Console(config-if)# bridge multicast address 0100.5e02.0203 add
ethernet 1/e11,1/e12
4-316
Console(config-if)# end
4-657
Console# show bridge multicast address-table
4-327
Vlan
----
226

Figure 3-113. Multicast Group Page

MAC Address
-----------
Type Ports
----- ----------