Show Ports Storm-Control - Alcatel OmniStack LS 6248 User Manual

Related Commands
port storm-control broadcast enable

show ports storm-control

show ports storm-control
The show ports storm-control
storm control configuration.
Syntax
show ports storm-control
Parameters
• interface — A valid Ethernet port. (Full syntax: unit/port)
Default Setting
This command has no default configuration.
Command Mode
User EXEC mode
Command Usage
There are no user guidelines for this command.
Example
The following example displays the storm control configuration .
show ports storm-control
Console#
Port State
---- --------
1/e1 Enabled
2/e1 Enabled
3/e1 Disabled
The following example displays the storm control configuration.
show ports storm-control
Console#
Unknown traffic limited to 1000
Kbits/sec
Port Broadcast and Multicast Storm Control [Kbits/Sec]
---- -------------------------------------------------
1/g1 8000
User/Privileged EXEC mode command displays the
[interface]
Rate [Kbits/ Included
Sec]
------------- ----------------------------------
--- ----
70 Broadcast, Multicast, Unknown
Unicast
100 Broadcast
100 Broadcast
Ethernet Configuration Commands
4
397