Common Cli Commands - Alcatel OMNISWITCH 7000 Getting Started Manual

Common CLI Commands

The following table lists some basic CLI commands that will
help you get acquainted with the CLI interface. Enter each
command exactly as shown. For complete descriptions of
these commands, refer to your CLI Reference Guide.
write memory
show running-directory
vlan
show vlan
ip interface
show chassis
show module
show ni
34 CLI Basics
Saves current configuration
changes to the /flash/working
directory's boot.cfg file. For
more information, refer to
page 26.
Displays the current running
directory. For more informa-
tion, refer to page 39.
Creates a new VLAN.
Displays a list of VLANs
configured on the switch.
Configures an IP interface to
enable IP routing on a VLAN.
Displays basic configuration
and status information for the
switch chassis.
Displays basic information for
switches in a stacked configu-
ration.
Displays basic hardware and
status information for a stand-
alone switch, or for all
switches installed in a stacked
configuration.
show cmm
show system
show microcode
session timeout
who
exit
Displays basic hardware and
status information for a stand-
alone switch, or for the primary
or secondary switches installed
in a stacked configuration.
Displays basic information
about the switch.
Displays the version of
software currently installed on
the switch.
Modifies the amount of time
before Telnet and console
sessions time out.
Displays all active login
sessions (e.g., Console, Telnet,
FTP, HTTP, Secure Shell,
Secure Shell FTP)
Ends the current Telnet or
console session.
March 2005