Operating Status Of Cmm-Related Components; Cli Commands Supported On Both The Primary And Secondary Cmms - Alcatel OmniSwitch 7700 Hardware User's Manual

Monitoring CMM Modules
The show hardware info command displays the following information:
CPU type
•
Flash manufacturer and flash size
•
RAM manufacturer and RAM size
•
NVRAM battery status
•
Jumper settings
•
BootROM and Miniboot versions
•
FPGA version(s)
•
For detailed information on the show hardware info command, including output table descriptions, refer
to the CLI Reference Guide.

Operating Status of CMM-Related Components

The CMM contains the switch's temperature sensor and monitors fan operation. If the TEMP or FAN
LEDs on the CMM's front panel indicate an error, you can use the
commands to access additional status information.
For information on reading temperature and fan status LEDs, refer to
For information on using the show temperature and show fan commands, as well as information on
temperature management and fan maintenance, refer to

CLI Commands Supported on Both the Primary and Secondary CMMs

Although most CLI commands are executed when logged into the primary CMM, there is a group of
commands that is supported when logged in to either the primary or secondary CMM. For a list of these
commands, refer to the tables below. The tables are grouped by chapter according to the OmniSwitch CLI
Reference Guide.
CMM Commands
reload
takeover
install
Chassis Management and Monitoring Commands
show system
show hardware info
show chassis
page 4-16
Chapter 2, "Chassis and Power Supplies."
debug chassis auto-reboot
show running-directory
show cmm
show ni
show module
OmniSwitch 7700/7800 Hardware Users Guide
Chassis Management Module (CMM)
show temperature and show fan
page 4-3.
show reload
show microcode
show module long
show module status
April 2005