Engine Oil Pressure Regulator; Oil Pump - BRP Cam-am Outlander 6x6 DPS 2015 Manual

Oil Pressure Switch Installation
vmr2015-114-002_a
1. Oil pressure switch
Apply required service product on threads of oil
pressure switch.
Tighten oil pressure switch to specification.
OIL PRESSURE SWITCH
Service product
Tightening torque
ENGINE OIL PRESSURE
REGULATOR
The oil pressure regulator is located on the engine
magneto side, integrated in the magneto cover.
vmr2015-114-003_a

1. Engine oil pressure regulator

NOTE: The oil pressure regulator system works
when the oil pressure exceeds 400 kPa (58 PSI).
vmr2015-114
Section 02 ENGINE, CVT AND GEARBOX
LOCTITE 243 (BLUE)
(P/N 293 800 060)
12 N•m ± 1 N•m
(106 lbf•in ± 9 lbf•in)
Subsection 04 (LUBRICATION SYSTEM)
Oil Pressure Regulator Access
To reach the pressure regulator (Outlander series),
refer to BODY and remove:
– RH side panel
– RH footboard panel.
Oil Pressure Regulator Removal
Remove plug screw and pull oil pressure regulator
out.
vmr2015-114-004_a
1. Plug screw
2. Gasket ring
3. Pressure regulator housing
4. Spring
5. Pressure regulator valve
Oil Pressure Regulator Inspection
Inspect pressure regulator housing and valve for
scoring or other damages.
Check spring for free length.
SPRING FREE LENGTH
NEW NOMINAL
SERVICE LIMIT
NOTE: Replace worn or damaged components.
Clean bore and thread in the magneto housing
from metal shavings and other contaminations.
Oil Pressure Regulator Installation
For installation, reverse the removal procedure.
Pay attention to the following details.
NOTE: At installation always replace the gasket
ring of the plug screw by a NEW one.

OIL PUMP

The oil pump is located on the engine PTO side
(behind PTO cover).
39 mm (1.535 in)
37 mm (1.457 in)
93