Magneto System - BRP Cam-am Outlander 6x6 DPS 2015 Manual

tmr2011-045-003_c
TYPICAL - PISTON AT TDC IGNITION
1. Printed marks on camshaft timing gear
2. Cylinder head base
4. Insert the crankshaft TDC position tool to lock
crankshaft in position. Refer to
TDC POSITION TOOL INSTALLATION
subsection.
Crankshaft TDC Position Tool Installation
Install tool in magneto cover CPS bore.
REQUIRED TOOL
CRANKSHAFT TDC POSITION
TOOL (P/N 529 036 201)
NOTE: Make sure to match the teeth on the
crankshaft TDC position tool with the magneto
rotor.
tmr2011-045-020_a
1. Crankshaft TDC position tool teeth (end view)
vmr2015-152
Section 02 ENGINE, CVT AND GEARBOX
vmr2015-033-008_a
MAGNETO COVER
1. Crankshaft TDC position tool installed in CPS bore
NOTICE
CRANKSHAFT
in this
vmr2015-033-009_a
1. Magneto cover
2. TDC position tool
TIMING CHAIN
Timing Chain Location
The engine is equipped with two timing chains.
– MAG side timing chain is located behind the
magneto cover.
– PTO side timing chain is located behind the PTO
cover.
Timing Chain Removal (MAG Side)
1. Refer to
remove following parts:
– Magneto cover
– Rotor
– Sprag clutch gear.
2. Refer to
following part:
– Valve cover.
Subsection 11 (TIMING CHAIN (650))
Tool must be fully inserted.

MAGNETO SYSTEM

TOP END subsection and remove the
subsection and
209