Sprag Clutch Gear - BRP Cam-am Outlander 6x6 DPS 2015 Manual

Section 02 ENGINE, CVT AND GEARBOX
Subsection 07 (MAGNETO AND STARTER)
vmr2006-041-013_a
1. Sprag clutch housing screws
2. Rotor
3. Sprag clutch
4. Sprag clutch housing
Sprag Clutch Inspection
Inspect sprag clutch and sprag clutch housing for
wear and damage.
Also check the collar of the sprag clutch gear.
Rotate sprag clutch gear in sprag clutch.
NOTE: Sprag clutch must lock in counterclock-
wise direction.
vmr2006-041-014_a
SPRAG CLUTCH FUNCTIONAL TEST
1. Lock
NOTE: Sprag clutch, housing and gear must be
replaced at the same time, if damaged.
Sprag Clutch Installation
For installation, reverse the removal procedure.
However, pay attention to the following details.
Apply
LOCTITE 648 (GREEN) (P/N 413 711 400)
threads of sprag clutch housing screws.
Install screws but do not torque yet.
Apply engine oil on sprag clutch and sprag clutch
gear needle bearing.
146
vmr2006-041-015_b
1. Sprag clutch
2. Sprag clutch housing

3. Sprag clutch gear

4. Apply engine oil here
Install rotor, refer to
Tighten sprag clutch housing screws to specifica-
tion.
SPRAG CLUTCH HOUSING SCREWS
Tightening torque
SPRAG CLUTCH GEAR
Sprag Clutch Gear Removal
ROTOR
Remove
tion.
Pull sprag clutch gear out of the rotor.
vmr2006-041-015_a
1. Rotor
on
2. Sprag clutch gear
Sprag Clutch Gear Inspection
Inspect gear, especially teeth and sprag clutch col-
lar, for wear and other damage.
ROTOR
in this subsection.
30 N•m ± 2 N•m
(22 lbf•ft ± 1 lbf•ft)
. See procedure in this subsec-
vmr2015-116