BRP Cam-am Outlander 6x6 DPS 2015 Manual page 342

Section 05 ELECTRICAL SYSTEM
Subsection 07 (LIGHTS, GAUGE AND ACCESSORIES)
Multifunction Gauge Test Using
B.U.D.S.
Connect to the latest applicable B.U.D.S. software
COMMUNICATION TOOLS
version. Refer to
AND B.U.D.S.
subsection.
Wow Test
This function is used to check if the indicator
lights, display and analog indicators (if applicable)
are functional.
NOTE: This function does not test the signals or
external circuits.
In B.U.D.S., select the:
– Activation page
– Cluster tab.
Click on the WOW Test button.
Indicator Lights Monitoring
In B.U.D.S., select the:
– Monitoring page
– Cluster tab.
Use the Cluster Lamp Active box to monitor dif-
ferent indicator lights outputs.
tmr2011-030-010
TYPICAL - CLUSTER LAMP ACTIVE BOX
This function confirms that the signals are broad-
casting and the indicator lights should be ON in
the multifunction gauge.
Switch Input Monitoring
In B.U.D.S., select the:
– Monitoring page
– Cluster tab.
Use the Switch Inputs box to monitor different
switch inputs as you activates the switches.
454
vmr2012-035-013
TYPICAL - SWITCH INPUTS BOX
This function confirms that the ECM receives the
inputs.
Vehicle Parameters Monitoring
In B.U.D.S., select the:
– Monitoring page
– Cluster tab.
In the upper area of the B.U.D.S. cluster page, the
following indications are displayed.
– Engine speed (RPM)
– Vehicle speed
– Fuel level
– Gear position.
These indications confirm that the applicable sig-
nals are transmitted and the information should be
displayed in the multifunction gauge.
Multifunction Gauge CAN Resistor Test
1. Disconnect DPS1 connector (control) from the
DPS module, refer to
section.
2. Remove seat to access diagnostic link connec-
tor (DB).
3. Remove diagnostic link connector from its
holder.
STEERING SYSTEM
sub-
vmr2015-137