BRP Cam-am Outlander 6x6 DPS 2015 Manual page 93

Section 02 ENGINE, CVT AND GEARBOX
Subsection 05 (COOLING SYSTEM (650))
tmr2011-011-009_a
CRANKCASE MAG SIDE
1. Water pump gear
2. Needle pin
3. Thrust washer
Water Pump Intermediate Drive Gear
1. Remove circlip retaining water pump interme-
diate drive gear and discard it.
tmr2011-011-013_a
CRANKCASE PTO SIDE
1. Water pump intermediate drive gear
2. Circlip
3. Water pump intermediate shaft
4. Crankcase PTO side
2. Remove the following parts:
– Water pump intermediate drive gear
– Needle pin.
Water Pump Drive Gear
BOTTOM END
See subsection.
Water Pump Gears Installation
Water Pump Gear
Install the following parts on water pump shaft.
– Thrust washer
116
– Needle pin
– Water pump gear.
NOTICE
A missing thrust washer will cause a
leaking rotary seal.
tmr2011-011-009_a
1. Water pump gear
2. Needle pin
3. Thrust washer
NOTE: Ensure water pump gear snaps properly
onto needle pin.
Install NEW circlip to retain water pump gear.
NOTICE
Never use the circlip a second time.
Always install a NEW one.
tmr2011-011-008_a
1. Circlip
2. Water pump gear
Water Pump Intermediate Drive Gear
Install the following parts on water pump interme-
diate shaft.
– Needle pin
– Water pump intermediate drive gear.
vmr2015-114