BRP Cam-am Outlander 6x6 DPS 2015 Manual page 435

7. Firmly hold trailing arm then remove:
– Shock absorber lower bolt
– Trailing arm pivot shaft (pull from opposite
side).
NOTE: If only one trailing arm is removed, pull
pivot shaft just enough to clear trailing arm.
sfvmr2014-010-038
1. Shock absorber lower bolt
2. Trailing arm pivot shaft
8. Remove trailing arm from vehicle.
Trailing Arm Disassembly
Drive Shaft Bearing Removal
1. Remove circlip securing bearing into trailing
arm.
vmr2015-144-005_a
TYPICAL
1. Circlip
2. Install trailing arm on a press.
3. Use an appropriate bearing remover.
4. Remove drive shaft bearing from trailing arm.
Link Arm Inner Sleeve Removal
Remove both bushings and inner sleeve from trail-
ing arm.
vmr2015-144
Section 07 CHASSIS
Subsection 05 (REAR SUSPENSION)
vmr2012-041-013_b
1. Bushings
2. Inner sleeve
Trailing Arm Pivot Bearing Removal
1. Remove both spacers and seals from trailing
arm pivot.
vmr2012-041-014_b
1. Spacers
2. Seals
2. Remove pivot bearings by pulling it outwards.
NOTE: Remove one bearing at a time.
3. Remove inner spacer from trailing arm.
551