BRP Cam-am Outlander 6x6 DPS 2015 Manual page 179

Subsection 15 (CONTINUOUSLY VARIABLE TRANSMISSION (CVT) (650))
2
R610tran18A
1. Soft hammer
2. Shaft
4. Remove shaft from ball bearing.
5. Remove distance sleeve and O-ring from coun-
tershaft.
6. Replace O-ring if brittle, hard or damaged.
vmr2006-021-044_b
1. O-ring
2. Distance sleeve
Driven Pulley Cleaning
When a dust deposit has to be removed from the
cam or the shaft, use a dry cloth.
Clean pulley faces and shaft using fine steel wool
and a dry cloth.
Clean driven pulley using the recommended prod-
uct.
RECOMMENDED PRODUCT
PULLEY FLANGE CLEANER (P/N 413 711 809)
Clean the CVT air guide area from contamination.
vmr2015-121
Section 02 ENGINE, CVT AND GEARBOX
Using a paper towel with
CLEANER (P/N 413 711 809)
1
end and shaft bore.
NOTICE
To avoid damage, make sure cleaner
does not contact the countershaft oil seal.
vmr2006-021-037_a
1. Countershaft support
2. Countershaft oil seal
Driven Pulley Inspection
Sliding Sheave
Check sliding sheave for cracks and sliding con-
tact surface for excessive wear. Replace sliding
sheave if necessary.
Check bushings for cracks, scratches and for
freedom of movement when assembled to slid-
ing sheave.
Measure bushing inner diameter.
NOTE: Bushings cannot be replaced. Replace
sliding sheave if bushings are out of specification.
Visually inspect coatings.
vmr2006-021-038_a
1. Bushings
2. Backside of sliding sheave of driven pulley
PULLEY FLANGE
, clean countershaft
287