Water Pump Impeller - BRP Cam-am Outlander 6x6 DPS 2015 Manual

vmr2015-115-001_a
1. Coolant drain plug
2. Sealing ring
3. Screws
4. Water pump housing
4. Pull water pump housing to remove it.
Water Pump Housing Inspection
Check if gasket is brittle, hard or damaged and re-
place as necessary.
vmr2006-040-009_a
1. Gasket
Water Pump Housing Installation
The installation is the reverse of the removal pro-
cedure. However, pay attention to the following.
NOTICE
To prevent leaking, take care that the
gasket is exactly in groove when you reinstall
the water pump housing.
Tighten screws of water pump housing in a criss-
cross sequence to specification.
WATER PUMP HOUSING SCREWS
Tightening torque
vmr2015-114
Section 02 ENGINE, CVT AND GEARBOX
10 N•m ± 1 N•m
(89 lbf•in ± 9 lbf•in)
Subsection 05 (COOLING SYSTEM (650))

WATER PUMP IMPELLER

Water Pump Impeller Removal
WATER PUMP HOUSING RE-
1. Proceed with
MOVAL
. See procedure in this subsection.
2. Remove impeller by unscrewing it counter-
clockwise.
vmr2015-115-002_a
1. Turn counterclockwise to unscrew
NOTICE
Water pump shaft and impeller have
right-hand threads.
Water Pump Impeller Inspection
Check impeller for cracks or other damage. Re-
place impeller if damaged.
Water Pump Impeller Installation
The installation is the reverse of the removal pro-
cedure. However, pay attention to the following.
NOTICE
Be careful not to damage impeller
fins during installation.
WATER PUMP SHAFT AND
SEALS
Use these guidelines to service these parts.
107