BRP Cam-am Outlander 6x6 DPS 2015 Manual page 387

GENERAL
The procedures described below are the same for
the RH and LH sides, unless otherwise instructed.
ADJUSTMENT
STEERING ALIGNMENT
1. Place vehicle on a level surface.
2. Check pressure in each tire. Adjust to recom-
mended pressure.
3. Lift and secure vehicle off the ground so that
the suspension is fully extended.
4. Position and secure handlebar in the straight
ahead position.
5. Remove two wheel nuts on the LH rear wheel
and install the steering alignment tool.
REQUIRED TOOL
STEERING ALIGNMENT
TOOL (P/N 529 036 059)
6. Place a rope around all four tires using an elas-
tic, link both ends together.
NOTE: The rope must be placed at the center of
the wheels.
7. Rotate the rear wheel to position the alignment
tool level with the rope. Ensure rope passes
over the spacer blocks on the alignment tool.
vmr2008-068-006_a
TYPICAL
1. Steering adjustment tool
2. Angle gauge or level
8. At the LH front of wheel, near the front of the
rim, pull on the rope so that it does not touch
the first spacer block on the alignment tool.
vmr2015-141
Section 07 CHASSIS
Subsection 02 (STEERING SYSTEM)
vmr2008-068-005_a
TYPICAL
9. Slowly move rope back until it just makes con-
tact with both spacers.
NOTE: Ensure rope remains in this position as
you carry out the following steps.
vmr2008-068-007
TYPICAL
10. Measure the distance between the rope and
the rim, at the front and at the rear of the
wheel rim.
vmr2008-068-008
TYPICAL — FRONT OF WHEEL
501