High Oil Consumption - BRP Cam-am Outlander 6x6 DPS 2015 Manual

2. Cylinder head or cylinder base gasket leak.
- Retighten cylinder head to specified torque, refer
to TOP END subsection. Replace gasket if tight-
ening does not solve the problem.
3. Engine internal damage.
- Repair engine.
4. Oil cooler gasket leak.
- Replace oil cooler gasket and change engine oil.

HIGH OIL CONSUMPTION

1. Leaking breather oil seal.
- Check if the oil seal of the breather is brittle, hard
or damaged. Refer to BOTTOM END subsection.
2. Valve stem seals worn or damaged.
- Replace valve stem seals.
3. Worn piston rings (blue exhaust smoke).
- Replace piston rings.
PROCEDURES
OIL COOLER
Oil Cooler Access
BODY
Refer to and remove rear part of RH inner
fender panel.
vmr2015-114-100_a
1. Remove
Oil Cooler Removal
PERIODIC MAINTENANCE PROCE-
Refer to
DURES
subsection to:
– Drain engine oil.
CHANGE
– Drain coolant. Refer to
PLACEMENT
.
Remove oil cooler retaining screws.
vmr2015-114
ENGINE OIL
Refer to
ENGINE COOLANT RE-
Section 02 ENGINE, CVT AND GEARBOX
Subsection 04 (LUBRICATION SYSTEM)
tmr2011-010-006_a
1. Retaining screws
2. Oil cooler
Place rags or towels under oil cooler to catch re-
maining oil and coolant.
Remove oil cooler and discard gasket.
tmr2011-010-007_a
1. Oil cooler
2. Gasket
Oil Cooler Inspection
Check oil cooler for cracks or other damage.
Replace if necessary.
Oil Cooler Installation
For installation, reverse the removal procedure.
Pay attention to the following details.
Wipe off any oil and coolant spillage.
Install a NEW gasket.
Refer to PERIODIC MAINTENANCE PROCE-
DURES subsection and carry out the following:
– Refill engine with recommended oil. See
GINE OIL CHANGE
– Refill and bleed cooling system. See
COOLANT REPLACEMENT
.
ENGINE
.
EN-
91