BRP Cam-am Outlander 6x6 DPS 2015 Manual page 315

Section 05 ELECTRICAL SYSTEM
Subsection 02 (WIRING HARNESS AND CONNECTORS)
vmr2008-139-016_a
1. ECM connector (harness side)
2. ECM adapter
NOTICE
Never probe directly on ECM har-
ness connector. This could change the shape
or enlarge the terminals and create intermit-
tent or permanent contact problems.
Molex Connector Inspection
Before replacing an ECM, always check electrical
connections.
1. Ensure connector locking mechanism is func-
tioning properly.
2. Ensure all wire terminals (pins) are properly
locked in the connector.
3. Ensure they are very tight, make good contact
with the pins in the ECM.
4. Ensure the pins in the harness connector
and the ECM connector are clean, shiny and
corrosion-free.
5. Check wiring harness for signs of scoring.
NOTE: A "defective ECM module" could possi-
bly be repaired simply by disconnecting and recon-
necting it.
NOTICE
Do not apply any lubricant product
to the pins of the ECM connector.
Molex Connector Terminal Removal
(Harness Connector)
To remove a signal terminal from the ECM har-
ness connector, use the
MOVER 2.25 (P/N 529 036 175)
To remove a power terminal, use the
NAL REMOVER 3.36 (P/N 529 036 174)
424
ECM TERMINAL RE-
.
ECM TERMI-
.
529036175
1. Remove rear protector from connector.
2. Pull out the connector lock.
smr2009-045-025_a
3. Insert tool to unlock terminal.
smr2009-045-026_a
1. Unlock here
4. Gently pull on the wire to extract the terminal
out the back of the connector.
vmr2015-132