BRP Cam-am Outlander 6x6 DPS 2015 Manual page 89

Section 02 ENGINE, CVT AND GEARBOX
Subsection 05 (COOLING SYSTEM (650))
14. Ensure that the rotary seal is going straight
into crankcase.
15. Remove rotary seal installation tools from
crankcase.
9 TO 15
16. Repeat steps
pletely seated in the crankcase.
vbs2008-011-037
ROTARY SEAL PROPERLY SEATED ON CRANKCASE
17. Carry out the final adjustment of the water
pump shaft as follows.
17.1 Install M8 nut (P/N 233 281 414) onto wa-
ter pump shaft.
17.2 Carefully thread M8 nut until the rotary
seal is flush with the end of water pump
shaft threads.
vbs2008-011-040
WATER PUMP SHAFT PROPERLY ADJUSTED WITH ROTARY
SEAL
NOTICE
The water pump shaft must
be properly adjusted with rotary seal.
The water pump shaft must move freely
while pushing it toward the crankcase.
18. Install the following parts, see procedure in
this subsection.
WATER PUMP IMPELLER
–
WATER PUMP HOUSING
–
112
until rotary seal is com-
.
19. Refill and bleed cooling system. Refer to
RIODIC MAINTENANCE PROCEDURES
section.
20. Check cooling system for leaks.
Water Pump Shaft and Seals
Replacement (Disassembled Engine)
Water Pump Shaft and Seals Removal
1. Remove the following parts, see procedure in
this subsection:
WATER PUMP HOUSING
–
WATER PUMP IMPELLER
–
– WATER PUMP GEARS
2. Push out water pump shaft with inner portion of
rotary seal from inside of crankcase MAG side.
REQUIRED TOOL
Soft hammer
tmr2011-011-010_a
1. Water pump shaft
2. Crankcase MAG side
3. Remove outer part of rotary seal using an ex-
pander.
REQUIRED TOOL
BLIND HOLE PULLER KIT
(P/N 529 036 056)
4. Install expander snugly against outer part of ro-
tary seal and pull seal out.
PE-
sub-
.
vmr2015-114