Front Oil Seal; Rear Oil Seal; Drive Shaft Removal/Installation - BRP Cam-am Outlander 6x6 DPS 2015 Manual

Front Bearing Cover Installation
tmr2011-014-004_a
FRONT OF ENGINE
1. Water pump cover
2. Oil seal front side
3. Oil cooler
4. Drive shaft
FRONT BEARING COVER SCREWS
Service product
Tightening torque
Engine Drive Shaft Installation
Finally check for axial play of the drive shaft.

FRONT OIL SEAL

(ENGINE DRIVE SHAFT)
Front Oil Seal Replacement
(Engine Drive Shaft)
NOTE: The front oil seal can be replaced with the
engine installed.
1. Remove front propeller shaft.
2. Remove adapter sleeve between propeller
shaft and front engine drive shaft.
3. Remove the front bearing cover, refer to
GINE DRIVE SHAFT REMOVAL/INSTALLATION
in this subsection.
4. Remove drive shaft seal from bearing cover.
vmr2015-120
Section 02 ENGINE, CVT AND GEARBOX
LOCTITE 243 (BLUE)
(P/N 293 800 060)
10 N•m ± 1 N•m
(89 lbf•in ± 9 lbf•in)
EN-
Subsection 13 (BOTTOM END (650))
tmr2013-018-005_a
1. Bearing cover
2. Oil seal
5. Install drive shaft oil seal using the following
tool.
REQUIRED TOOL
DRIVE SHAFT OIL SEAL
INSTALLER (P/N 529 036 028)
vmr2013-018-002_a
1. Bearing cover
2. Oil seal
3. Oil seal installer
6. Reinstall remaining parts in the reverse order of
removal.

REAR OIL SEAL

(ENGINE DRIVE SHAFT)
Rear Oil Seal Replacement
(Engine Drive Shaft)
1. Remove gearbox from the engine, refer to
GEARBOX AND COUPLING UNIT
2. Remove rear bearing cover, refer to

DRIVE SHAFT REMOVAL/INSTALLATION

this subsection.
subsection.
ENGINE
in
231