Torque Offset Reset - BRP Cam-am Outlander 6x6 DPS 2015 Manual

Section 07 CHASSIS
Subsection 03 (DYNAMIC POWER STEERING (DPS))
5. With the vehicle engine running in PARK, turn
the handlebar side to side, momentarily against
each stop and observe the indications on the
B.U.D.S. DPS Monitoring page.
The DPS Torque Sensor Nm increase with torque
applied to handlebar.
The DPS Current ammeter should increase pro-
portionately to the torque applied, and decrease
with the torque as steering assist is provided.
vmr2010-003-009_a
TYPICAL - LH TURN
1. Torque sensor indication (negative)
2. DPS current indication (positive)
vmr2010-003-010_a
TYPICAL - RH TURN
1. Torque sensor indication (positive)
2. DPS current indication (negative)
NOTE: Increase and decrease in torque and cur-
rent readings is very brief as steering assist is
quickly provided. Current draw should remain
within green scale but may momentarily peak to
60 amps, then drop off close to 0 amps as torque
applied is nulled out by steering assist. A residual
torque of 2 N•m (18 lbf•in) with a corresponding
current draw is acceptable.
If current draw tends to remain high, carry out the
following:
– Steering alignment check.
524
– Steering column shim adjustment at half bush-
ings as described in the
TION
procedure detailed in this section.

TORQUE OFFSET RESET

–
this section.
– Replace DPS unit.
DPS Unit Removal
1. Remove the front body module, refer to
subsection.
2. Remove both inner fender panels
3. Remove the CVT air inlet duct assembly, refer
AIR INTAKE SYSTEM
to
4. Disconnect the 3 electrical connectors from the
DPS unit.
vmr2010-003-013_a
TYPICAL
1. DPS connectors (3x)
5. Cut the locking tie securing the bellows at the
bottom of steering column near the DPS unit,
and pull the bellows upwards sufficiently to ac-
cess the steering column pinch bolt.
vmr2010-003-016_a
TYPICAL
1. Cut this locking tie
2. Steering column bellows
DPS UNIT INSTALLA-
procedure detailed in
BODY
subsection.
vmr2015-142