BRP Cam-am Outlander 6x6 DPS 2015 Manual page 323

tmr2011-026-002_a
1. Ignition coil connector
2. Set emergency engine stop switch to RUN.
3. Turn ignition switch to ON.
4. Read voltage as per following table.
REQUIRED TOOL
FLUKE 115 MULTIMETER
(P/N 529 035 868)
IGNITION COIL INPUT VOLTAGE TEST
IGNITION COIL
CONNECTOR
Pin 2 with battery ground
Battery voltage should be read.
If Battery voltage is NOT read, check continuity of
ignition coil supply circuit. Refer to
GRAM .
Ignition Coil Ground Circuit Continuity
Test
1. Disconnect the ECM connector and connect
it to the ECM adapter tool. Refer to
TRONIC FUEL INJECTION (EFI)
vmr2015-133
vmr2012-031-005_b
TYPICAL
1. ECM
2. ECM connector cover
VOLTAGE
2. Check wiring continuity as per following table.
Battery voltage
WIRING DIA-
ELEC-
Ignition Coil Resistance Test
subsection.
An ignition coil with good resistance measure-
ment can still be faulty. Voltage leakage can occur
at high voltage levels which is not detectable with
an ohmmeter. Replacing the ignition coil may be
necessary as a test.
Primary Windings
1. Disconnect HIC2 connector.
Section 05 ELECTRICAL SYSTEM
Subsection 03 (IGNITION SYSTEM)
REQUIRED TOOLS
ECM ADAPTER TOOL
(P/N 529 036 166)
FLUKE 115 MULTIMETER
(P/N 529 035 868)
IGNITION COIL GROUND CIRCUIT
CONTINUITY TEST
PIN
(IGNITION
COMPONENT
COIL
CONNECTOR)
Cylinder 1 (front)
Cylinder 2 (rear)
PIN
(ECM
CONNECTOR)
1 M1
3 M2
433