BRP Cam-am Outlander 6x6 DPS 2015 Manual page 410

6. Remove the steering column pinch bolt and re-
taining nut. Discard the retaining nut.
vmr2010-003-017_a
TYPICAL
1. Steering column pinch bolt
7. Remove the hardware that secures both tie-rod
ends to the pitman arm (steering lever). Discard
cotter pins.
vmr2010-003-022_a
TYPICAL
1. Pitman arm
2. Tie rod ends
8. Turn the steering to each side and disengage
each tie-rod end from the pitman arm.
vmr2015-142
Subsection 03 (DYNAMIC POWER STEERING (DPS))
vmr2010-003-023
TYPICAL - TIE ROD ENDS (HARDWARE REMOVED)
9. Pull up on the steering column to partly disen-
gage it from the DPS unit.
NOTE: A mechanical stop on the steering column
will prevent you from fully disengaging the steer-
ing column.
10. Remove the lower half bushing retainer that
secures the steering shaft to the frame.
vmr2012-039-013_a
1. Lower half bushing retainer
2. Bolts to remove (2)
11. Remove the 2 hexagonal flanged screws se-
curing the DPS unit to the RH support bracket.
Section 07 CHASSIS
525