BRP Cam-am Outlander 6x6 DPS 2015 Manual page 280

Section 04 FUEL SYSTEM
Subsection 01 (ELECTRONIC FUEL INJECTION (EFI))
CTS Access
Remove the LH panel. Refer to
Remove the CVT duct.
vmr2015-129-008
CTS Resistance Test
1. Disconnect the ECM connector.
2. Install the ECM adaptor on the ECM connector.
3. Using a multimeter, check resistance as per fol-
lowing table.
ECM ADAPTER
PIN
F4
C3
If resistance value is incorrect, check wiring con-
tinuity between ECM connector and the CTS. Re-
CTS CIRCUIT CONTINUITY TEST
fer to
section.
CTS Circuit Continuity Test
1. Disconnect connector from CTS and check the
circuit continuity.
CTS CIRCUIT CONTINUITY TEST
ECM CTS
ADAPTER CONNECTOR
Pin F4 Pin 1
Pin C3 Pin 2
If resistance value is incorrect, repair or replace
wiring or connectors/terminals.
If resistance test is good, replace the CTS.
388
CTS Replacement
BODY subsection. 1. Refer to
2. Remove heat shield over exhaust pipe to ex-
3. Disconnect CTS connector and remove CTS.
4. Install the new CTS and torque as specified.
MEASUREMENT
RESISTANCE ( )
5. Reinstall remaining removed parts.
@ 20°C (68°F)
6. Refill and bleed the cooling system. Refer to
2280 - 2736
in this sub-
RESISTANCE
VALUE
Close to 0
CTS ACCESS
reach CTS.
EXHAUST SYSTEM
pose CTS. Refer to
vmr2015-129-009
CTS TORQUE
16 N•m ± 2 N•m (142 lbf•in ± 18 lbf•in)
COOLING SYSTEM subsection.
in this subsection to
.
vmr2015-129