Battery Cleaning - BRP Cam-am Outlander 6x6 DPS 2015 Manual

Table of Contents

Advertisement

Battery Storage
It is not necessary to remove the battery during
vehicle storage but it is recommended for long
term storage.
If the battery is left in the vehicle during storage or
used infrequently, disconnect the BLACK (-) nega-
tive battery cable to eliminate battery current drain
from the electrical equipment.
Recharge the battery once a month with an ap-
proved battery charger as per manufacturer's rec-
ommendations.
Clean battery, battery support and connections as
required, refer to

BATTERY CLEANING

tion.
For other recommendations during storage, refer
to battery manufacturers instructions.
WARNING
Ensure battery is stored in a safe place, out of
reach for children.
New Battery Activation
Refer to the instructions provided with the battery.
Battery Charging
WARNING
Always wear safety glasses and charge in a
well ventilated area. Never charge or boost a
battery while it is installed on vehicle. Do not
open the sealed cap during charging. Do not
place battery near open flame.
NOTICE
If battery becomes hot, stop charg-
ing and allow it to cool before continuing.
NOTE: Sealed VRLA batteries have an internal
safety valve. If battery pressure increases due to
overcharging, the valve opens to release excess
pressure, preventing battery damage.
An automatic charger is a fast and convenient way
for error-proof charging.
Always follow the battery manufacturer's charg-
ing instructions.
When using a constant current charger, charge
battery according to the chart below.
vmr2015-134
Section 05 ELECTRICAL SYSTEM
Subsection 04 (CHARGING SYSTEM)
Battery Voltage Below 12.8 V and Above 11.5
V
BATTERY
TYPE
YTX20L-BS
BATTERY
TYPE
YTX20L-BS
in this sec-
Battery Installation
NOTICE
then BLACK (-) cable.
Installation is the reverse of removal procedure,
however pay attention to the following.
Battery retaining plate
STANDARD CHARGING
(RECOMMENDED)
TIME
4 - 9 HOURS
QUICK CHARGING
TIME
50 MINUTES
Always connect RED (+) cable first
TIGHTENING TORQUE
4.5 N•m ± 0.5 N•m
screws
(40 lbf•in ± 4 lbf•in)
CHARGE
2 A
CHARGE
10 A
439

Advertisement

Table of Contents
loading

Table of Contents