BRP Cam-am Outlander 6x6 DPS 2015 Manual page 340

Section 05 ELECTRICAL SYSTEM
Subsection 07 (LIGHTS, GAUGE AND ACCESSORIES)
MULTIFUNCTION GAUGE
COMMUNICATION ERROR
1. Multifunction gauge CAN circuit open.
- Ensure multifunction gauge is properly connected
and powered up.
- Check for applicable fault code using B.U.D.S.,
refer to MONITORING SYSTEM AND FAULT
CODES subsection.
- Carry out a MULTIFUNCTION GAUGE CAN RE-
SISTOR TEST in this subsection.
- Carry out a continuity test of the multifunction
gauge CAN wires, refer to WIRING DIAGRAM.
NO FUEL QUANTITY INDICATION
1. Defective fuel level sender or wiring.
- Refer to FUEL TANK AND FUEL PUMP subsec-
tion.
2. Defective Multifunction Gauge.
- Replace multifunction gauge, refer to MULTI-
FUNCTION GAUGE in this subsection.
DIAGNOSTIC GUIDELINES
(LIGHTS)
LOW AND HIGH BEAM HEADLIGHTS WILL
NOT COME ON SIMULTANEOUSLY
1. Jumper JP1 is open circuit or missing.
- Check jumper (fuse) JP1 in front fuse box, refer
to POWER DISTRIBUTION subsection.
BRAKE LIGHTS WILL NOT COME ON
WHEN BRAKES APPLIED
1. Defective brake relay.
- Test brake relay (R8), refer to POWER DISTRIBU-
TION subsection.
2. Defective brake light switch(es).
- Refer to BRAKE LIGHT SWITCHES in the BRAKE
subsection.
3. Defective wiring/connectors.
- Test wiring continuity, refer to applicable WIRING
DIAGRAM.
PROCEDURES
MULTIFUNCTION GAUGE
Maintenance Required Message Reset
Connect to the latest applicable B.U.D.S. software
COMMUNICATION TOOLS
version. Refer to
AND B.U.D.S.
subsection.
Select Vehicle tab.
Click on the Reset Service button.
452
tmr2011-030-014_a
TYPICAL
1. Reset Service button
Multifunction Gauge Wire
Identification
FUNCTION
12 volt input from fuse F4 17
12 volt input from
fuse F10 (Clock)
Ground
CAN LO
CAN HI
Fuel level gauge supply
Fuel level gauge ground
2WD/4WD switch
signal (-)
HI beam signal (+)
Vehicle speed sensor
signal (VSS)
Multifunction Gauge Circuit Protection
CONDITION
Supplied at all times
Supplied with main relay
activated
Clock Setting Using Gauge Selector
Button
To set current time, proceed as follows:
1. Select the clock display.
PIN COLOR
OR/YL
16 RD/WH
20 BK
18
BE/GN
19 WH/BE
4
BR/PK
21 VI/PK
7
BK/BE
5
BU
9 PK
CIRCUIT PROTECTION
Fuse 10 of fuse block 1
(from fuse 1 of fuse
block 2)
Fuse 4 of fuse block 1
(from main relay R2)
vmr2015-137