Required Tool - BRP Cam-am Outlander 6x6 DPS 2015 Manual

Section 02 ENGINE, CVT AND GEARBOX
Subsection 05 (COOLING SYSTEM (650))
tmr2011-011-056_a
Seals Installation
1. Apply engine oil on water pump shaft.
2. Apply grease on the lips of the oil seal.
3. Carefully install oil seal over the water pump
shaft.
4. Push oil seal into the water pump cavity.

REQUIRED TOOL

17 mm (11/16 in) deep socket
vbs2008-011-034
OIL SEAL INSTALLATION
5. Ensure that the oil seal is properly seated in wa-
ter pump cavity.
110
vbs2008-011-035_a
TYPICAL
1. Oil seal properly seated
6. Apply engine oil on water pump shaft.
7. Place rotary seal onto water pump shaft and pull
out water pump shaft by hand.
NOTICE
Do not install the rotary seal com-
pletely into the crankcase to prevent the water
pump shaft plastic gear from breaking. Push it
partially in, then pull the shaft.
8. Place a robust M8 flat washer (P/N 420 227
935) onto water pump shaft.
9. Install a M8 nut (P/N 233 281 414) onto water
pump shaft by hand.
10. Thread nut 1-1/2 turns to pull the shaft into
rotary seal.
tmr2011-011-057_a
1. Rotary seal
2. M8 robust flat washer
3. M8 nut
11. Remove M8 nut.
NOTE: The robust M8 flat washer must remain on
water pump shaft.
vmr2015-114