Power Distribution - BRP Cam-am Outlander 6x6 DPS 2015 Manual

ECM Connector
There is one connector connected to the ECM. It
links:
– Engine harness
– Vehicle system control harness.
NOTE: For connector information, cleaning and
WIRING HARNESS AND CON-
probing, refer to
NECTORS
subsection.
ECM Adapter Tool
To probe ECM connector terminals, use the
ADAPTER TOOL (P/N 529 036 166)
529036166
NOTE: This tool will prevent deforming or enlarg-
ing terminals which would lead to bad ECM ter-
minal contact creating intermittent or permanent
problems.
ECM Power Supply Test
1. Disconnect ECM connector.
2. Install the ECM adapter on the ECM connector.
3. Install a jumper wire between K1 and M4 on the
ECM adapter tool.
4. Use the
FLUKE 115 MULTIMETER (P/N 529 035
and check voltage as per following table.
868)
529035868
ECM
BATTERY
ADAPTER
L1 Negative post
vmr2015-129
Subsection 01 (ELECTRONIC FUEL INJECTION (EFI))
If voltage is not measured, check the following:
– ECM fuse
– Main relay
– Wiring and connections, refer to the
Continuity Test of ECM Ground
Circuits
1. Disconnect ECM connector.
2. Install the ECM adapter on the ECM connector.
ECM
3. Using a multimeter, check resistance as per fol-
.
smr2009-030-010_a
If any measurement is out of specification, refer to

POWER DISTRIBUTION

CAN Resistor Test
Remove the DPS1 connector (4-pin connector)
from DPS module (if so equipped). Refer to
STEERING SYSTEM
1. Remove seat to access the diagnostic link con-
2. Remove diagnostic link connector from its
VOLTAGE
Battery voltage
Section 04 FUEL SYSTEM
DIAGRAM .
lowing table.
ECM BATTERY
ADAPTER POST
Pins G1, M3
Ground
and M4
and check all grounds.
subsection.
nector (DB).
holder.
WIRING
RESISTANCE
Close to 0
(continuity)
371