Propeller Shaft - BRP Cam-am Outlander 6x6 DPS 2015 Manual

Remove boot from drive shaft.
Remove and discard the circlip. A new one is in-
cluded in the boot kit.
With the Special Tool
Place drive shaft in vice with the joint downward.
Install the
CV JOINT EXTRACTOR (P/N 529 036 005)
on bearing.
529036005
vmr2007-053-010_b
TYPICAL — CV JOINT SHOWN
1. Joint extractor tool
With an hammer, hit on the tool to separate joint
from shaft.
When joint and shaft are separated, remove boot
from drive shaft.
Remove and discard the circlip. A new one is in-
cluded in the boot kit.
Remove drive shaft boot.
Drive Shaft Boot Installation
The installation is the reverse of the removal pro-
cedure. However, pay attention to the following:
Pack bearing area with grease (included with the
new boot kit).
NOTE: Do not use any other grease.
vmr2015-139
Section 06 DRIVE SYSTEM
Subsection 02 (MIDDLE AND REAR FINAL DRIVE)

PROPELLER SHAFT

Middle Propeller Shaft Removal
vmr2015-139-002_a
1. Remove middle drive. Refer to
REMOVAL
2. Detach brake master cylinder from frame.
vmr2015-058-004_b
3. From RH side of vehicle, remove propeller shaft
screw from gearbox output shaft.
NOTE: Heat screw to break the threadlocker
bond prior to removal.
MIDDLE DRIVE
in this subsection.
483