BRP Cam-am Outlander 6x6 DPS 2015 Manual page 417

Section 07 CHASSIS
Subsection 03 (DYNAMIC POWER STEERING (DPS))
REQUIRED TOOLS
PITMAN ARM JIG
(P/N 529 036 225)
4. Insert the DPS input shaft in the Pitman arm jig
receptacle with the Pitman arm facing up.
vmr2012-039-025_a
1. DPS input shaft
2. Shaft receptacle in Pitman arm jig
vmr2012-039-023_a
1. Pitman arm jig in vice
2. Pitman arm up
3. DPS input shaft inserted in jig
5. Insert the positioning adapter in the Pitman arm
so its point rests in the DPS output shaft.
NOTE: A countersunk hole is machined in tip of
the DPS output shaft to accept and center the po-
sitioning adapter point.
532
REQUIRED TOOL
POSITIONING
ADAPTOR
(P/N 529 036 230)
vmr2012-039-024_a
1. Pitman arm
2. Positioning adapter
6. Turn the jig positioning screw until the screw tip
rests snugly in the positioning adapter.
vmr2012-039-026_a
1. Jig screw tip
2. Positioning adapter
7. Turn the extractor nut down until their is no
space between the extractor and the position-
ing tip.
vmr2015-142