BRP Cam-am Outlander 6x6 DPS 2015 Manual page 382

Section 06 DRIVE SYSTEM
Subsection 02 (MIDDLE AND REAR FINAL DRIVE)
vmr2015-052-013_a
TYPICAL
Install NEW bearings.
vmr2015-052-014_a
TYPICAL
Tighten final drive housing screws to specification.
TIGHTENING TORQUE
Final drive housing
screws
Pinion Gear Installation
The installation is the reverse of the removal pro-
cedure. However, pay attention to the following.
Install a NEW needle bearing.
Install the shim(s) then a NEW ball bearing.
install a NEW O-ring.
Apply
LOCTITE 277 (P/N 293 800 073)
Install and tighten the pinion nut to specification.
496
32 N•m ± 3 N•m
(24 lbf•ft ± 2 lbf•ft)
to pinion nut.
TIGHTENING TORQUE
Pinion nut
Lubricate and install a NEW oil seal.
Rear Final Drive Installation
The installation is the reverse of the removal pro-
cedure. However, pay attention to the following.
Install the lowest rear final drive retaining screws
first.
Install all screws and nuts prior to tighten.
Tighten nuts to specification.
TIGHTENING TORQUE
Final drive retaining nuts
Refill the final drive with recommended oil. Re-
PERIODIC MAINTENANCE PROCEDURES
fer to
subsection.
180 N•m ± 15 N•m
(133 lbf•ft ± 11 lbf•ft)
+
LOCTITE 277 (P/N 293
800 073)
90 N•m ± 5 N•m
(66 lbf•ft ± 4 lbf•ft)
vmr2015-139