BRP Cam-am Outlander 6x6 DPS 2015 Manual page 178

Section 02 ENGINE, CVT AND GEARBOX
Subsection 15 (CONTINUOUSLY VARIABLE TRANSMISSION (CVT) (650))
Vmr2012-018-011_a
1. Driven pulley screw
2. Thrust washer
6. Remove the driven pulley with the spring and
the cam.
Vmr2012-018-012_a
1. Fixed sheave of driven pulley
2. Sliding sheave of driven pulley
3. Spring
4. Cam
Driven Pulley Disassembly
Fixed Sheave
1. Remove retaining ring and lift torque gear.
286
vmr2006-021-035_a
1. Retaining ring
2. Torque gear
3. Fixed sheave of driven pulley
NOTE: The following procedure is not necessary
except if ball bearing or shaft must be removed.
INSPECTION
Refer to before proceeding.
2. Heat ball bearing area up to 100°C (212°F) be-
fore removing ball bearing.
tmr2011-015-009_a
1. Ball bearing
2. Shaft
3. Fixed sheave of driven pulley
3. Use a soft hammer to push shaft and bearing
out of fixed sheave.
vmr2015-121