Master Cylinder - BRP Cam-am Outlander 6x6 DPS 2015 Manual

Section 07 CHASSIS
Subsection 06 (BRAKES)
vmr2015-058-007_a
TIGHTENING SEQUENCE
Step 1: Tighten bolt
Step 2: Hold bolt then tighten nut

MASTER CYLINDER

Master Cylinder Removal
1. Remove BRAKE PEDAL
subsection.
2. Remove master cylinder from support.
vmr2015-058-008_a
3. Remove hoses and bleeder from master cylin-
der.
Master Cylinder Inspection
Check boot for crack.
Check rod for wear and scratch.
Check master cylinder housing for leak or dam-
age.
Master Cylinder Installation
The installation is the reverse of the removal pro-
cedure. However, pay attention to the following.
Install NEW sealing washers.
Tighten brake hoses and bleeder to specification.
562
. See procedure in this
TIGHTENING TORQUE
Brake hose screw
(banjo fitting)
Bleeder
Refill and bleed brake system, refer to
MAINTENANCE PROCEDURES
CALIPER
Caliper Removal
1. Safely lift and support the vehicle.
2. Remove wheel, refer to
subsection.
3. If caliper is removed from vehicle for replace-
ment:
3.1 Drain brake system, refer to
MAINTENANCE PROCEDURES
tion.
3.2 Unscrew brake hose from caliper.
tmr2011-037-010_a
TYPICAL
1. Brake hose
2. Sealing washers
4. Remove fasteners retaining brake hose.
5. Remove screws securing caliper support.
28.5 N•m ± 1.5 N•m
(21 lbf•ft ± 1 lbf•ft)
8.5 N•m ± 1.5 N•m
(75 lbf•in ± 13 lbf•in)
PERIODIC
subsection.
WHEELS AND TIRES
PERIODIC
subsec-
vmr2015-145