Upper Suspension Arm - BRP Cam-am Outlander 6x6 DPS 2015 Manual

vmr2015-056-002_a
4. Remove screws and nuts securing suspension
arm to frame.
vmr2012-040-003_a
1. Suspension arm screws
5. Remove suspension arm.
vmr2012-040-004_a
MOVE OUTWARDS
Lower Suspension Arm Installation
The installation is the reverse of the removal pro-
cedure. However, pay attention to the following.
vmr2015-056
Section 07 CHASSIS
Subsection 04 (FRONT SUSPENSION)
Lubricate suspension arm. Refer to
MAINTENANCE PROCEDURES
Tighten ball joint nut to specification.
TIGHTENING TORQUE
Nut securing ball joint
to knuckle
Perform steering alignment procedure. Refer to
STEERING ALIGNMENT

UPPER SUSPENSION ARM

Upper Suspension Arm Removal
1. Safely lift and support the vehicle off the
ground.
2. Remove wheel, refer to
subsection.
3. Remove fasteners retaining brake hose to vehi-
cle.
vsi2015-143-004
4. Remove and discard cotter pin retaining ball
joint.
vsi2015-143-005
5. Remove ball joint nut and washer.
PERIODIC
subsection.
48 N•m ± 6 N•m
(35 lbf•ft ± 4 lbf•ft)
subsection.
WHEELS AND TIRES
541