Starting System - BRP Cam-am Outlander 6x6 DPS 2015 Manual

STARTING SYSTEM

SERVICE TOOLS
Description
ECM ADAPTER TOOL (ONE CONNECTOR).................................
FLUKE 115 MULTIMETER ............................................................
GENERAL
STARTING SYSTEM OPERATION
When the START button is pressed, 12 Vdc is ap-
plied through the start switch (MG1) to the starter
solenoid coil. If the engine cranking conditions are
met, the ECM completes the starter solenoid con-
trol circuit by providing a ground. The starter so-
lenoid then closes its contacts and battery power
is applied to the starter for cranking the engine.
Engine Cranking Conditions
The following conditions must be met to allow en-
gine cranking.
– Ignition switch turned ON
– Engine stop switch to RUN
– Transmission in Park, Neutral or a brake
pedal/lever is applied
– Start button is pressed and held.
TROUBLESHOOTING
Check for fault codes. Refer to:
AND FAULT CODES
subsection.
ENGINE WILL NOT TURN
If the starter cranks over the engine with the
brakes applied, check the shifter adjustment and
the gearbox position sensor and wiring. Refer
SHIFTER GEARBOX AND COUPLING
to the and
UNIT
sections.
If the "Engine cranking conditions" are met and
the starter will not crank the engine, check the fol-
lowing:
1. Battery and connections (refer to
SYSTEM )
2. Starter solenoid
3. Start button switch
MAGNETO AND STARTER
4. Starter (refer to
subsection)
5. Wiring and connections.
vmr2015-135
ENGINE TURNS
Starting system is OK.
1. Verify ignition system. Refer to
TEM
2. Verify EFI systems. Refer to
FUEL INJECTION (EFI)
3. Verify mechanical condition of engine. Refer to
ENGINE, CVT AND GEARBOX
PROCEDURES
Ensure battery is fully charged.
Refer to applicable
NECTORS
tions on vehicle.
Refer to applicable
tional information.
Ensure vehicle is in PARK when performing
starting system tests.
DIAGNOSTIC
STARTING SYSTEM TESTS
Starter Solenoid
CHARGING
vmr2015-135-001_a
1. Disconnect SS1 and SS2
Section 05 ELECTRICAL SYSTEM
Subsection 05 (STARTING SYSTEM)
Part Number
529 036 085 ......................................... 443
529 035 868 ......................................... 445
subsection.
subsection.
WIRING HARNESS AND CON-
for harness layout and connector loca-
WIRING DIAGRAM
WARNING
Page
IGNITION SYS-
ELECTRONIC
section.
for addi-
441