Electronic Fuel Injection - BRP Cam-am Outlander 6x6 DPS 2015 Manual

TEST CONDITION
Start button
Engine
‡ Will prevent engine from starting
1. Measure voltage drop.
vmr2015-135-004_a
PROBE PROBE
Starter B+
BAT1
terminal
If voltage drop is above specification, repair or re-
place sources of high resistance in circuit.
Starter Solenoid Ground Circuit
SS2-
L3
HIC1-J
B4
G2
K3
A4
vmr2015-048-005_a
1. Disconnect SS2.
2. Install the ECM connector onto the
ADAPTER TOOL (ONE CONNECTOR) (P/N 529
036 085)
vmr2015-135
Pressed
Cranking
vmr2008-139-016_a
1. ECM connector
2. ECM adapter tool
If resistance is not as specified, repair or replace
wiring/connections.
If solenoid power control circuit and ground con-
trol circuit both test good, test ECM ground
circuits. Refer to
(EFI)
SPECIFICATION
NOTE: Supply a ground with a jumper wire if you
Below 0.4 Vdc
suspect that the ECM is not supplying a ground to
the solenoid.
Starter Solenoid Continuity
1. Disconnect the black (-) negative battery cable.
2. Disconnect SS1 and SS2
SS1-
vmr2015-048-012_a
1. SS1
ECM
Section 05 ELECTRICAL SYSTEM
Subsection 05 (STARTING SYSTEM)
PROBE PROBE
SS2 ECM-L3

ELECTRONIC FUEL INJECTION

section.
SPECIFICATION
Close to 0
443